Cybersmart - FAQ

How to setup the Tenda Router

• Open Internet Explorer and type in the address bar 192.168.1.1 and press enter.

• Enter the Username and Password in the login box.
• Username : admin
• Password : admin
• This will bring you to the setup page, click on Wizard on the left which will take you through the wizard setup.
• Enter settings as displayed below.

• Country : Default
• Area : 8/35
• VPI : 8
• VCI : 35
• Enable Quality of Service must not be ticked
• Click next to go to step 2 of the wizard setup

• Connection Type : PPP over Ethernet ( PPPoE)
• Encapsulation Mode : LLC/SNAP-BRIDGING
• Click next to go to step 3 of the wizard setup

• PPP Username : Enter your username that was supplied by Cybersmart
• PPP Password : Enter your password that was supplied by Cybersmart
• PPPoE Service Name : Blank
• Authentication Method : Auto
• MTU : 1492
• Dial on Demand : no tick in box
• PPP IP Extension : no tick in box
• Use Static IP Address : no tick in box
• Retry PPP password on authentication error : no tick in box
• Bridge PPPoE Frames Between WAN and Local Ports ( Default Enabled ) : box must be ticked
• Click next to go to step 4 of the wizard setup

• Enable IGMP Multicast : no tick in box
• Enable WAN Service : box must have a tick
• Service Name : pppoe_8_35_1
• Click next to go to step 5 of the wizard setup

• This will show the WAN Setup – Summary
• Click Save/Reboot
• This will save the settings and reboot the router